1、 產品簡介

　　Product introduction

　　水力沖洗裝置是一種用于清洗雨水調蓄池和大型管道的裝置。

　　通常，在現有調蓄池中經過簡單改造后即可安裝門式自動沖洗系統，不會減少調蓄池的調蓄容量。系統運行可靠、穩定，一般情況下經過一次沖洗即可將大顆粒沉積物甚至大石塊沖刷干凈，這已經在實際工程應用中得到驗證。

　　A hydraulic flushing device is a device for cleaning rainwater storage tanks and large pipelines. Usually, in the existing storage tank after a simple transformation can be installed door-type automatic flushing system, will not reduce the storage tank storage capacity. The system is reliable and stable, and under normal conditions, it can wash the large sediment and even the large stones by a flush, which has been verified in the practical engineering application.

　　水力沖洗裝置的主要運行過程如下：

　　蓄水——首先，將雨水調蓄池劃分為多個沖洗廊道。然后在每一個沖洗廊道中分離出一座單獨儲水間，用于在調蓄池日常進水時存儲來水，作為清洗調蓄池的沖洗水源。

　　調蓄池清空——水中污染物沉淀于池底需要清洗時，首先排空雨水調蓄池，通過PLC控制系統啟動液壓系統，將儲水間之前的沖洗門開啟，開始對廊道進行清洗。

　　沖洗——沖洗門開啟之后，儲水間內的水源產生強大的沖洗水流(類似水壩放水)，對調蓄池各廊道底部進行沖洗。沖洗完畢后沖洗門恢復原位，等待下次蓄水沖洗。

　　The main operation process of the hydraulic flushing device is as follows:

　　Water storage-first, the rainwater storage pool is divided into several flushing corridors. A separate water storage compartment is isolated from each flushing corridor for storing water during the daily water intake of the reservoir, as a flushing water source for cleaning and regulating storage tanks.

　　The storage tank is emptied--the water pollutant precipitates in the pool bottom and needs to be cleaned, first empties the rainwater to adjust the storage pond, starts the hydraulic system through the PLC control system, opens the flushing door before the water storage room, starts to the corridor to clean.

　　Flush-After the flush, door is opened, the water source in the storage room produces a powerful flushing flow (similar to a dam), which is rinsed at the bottom of each corridor of the storage tank. The door returns back in place after flushing and wait for the next flush.

　　2、 性能優點

　　Performance and Benefits

　　■ 水力沖洗裝置的主體結構采用不銹鋼制做，結構堅固，耐腐蝕。

　　■ 水力沖洗裝置沖洗效果好，沖洗效率高，單個沖洗門的有效沖洗長度就可超過100m。

　　■ 水力沖洗裝置控制全自動化進行，無需人工操作。

　　■ 水力沖洗裝置儲水間底部進水方式，即使調蓄池未處于滿池狀態，也能保證儲水間自動充滿。

　　■ 水力沖洗裝置無噪聲，無需外動力，無需外部水源，節省能源，保護環境。

　　■ The main structure of the hydraulic flushing device is made of stainless steel, solid structure and corrosion resistance.

　　■ The flushing effect of the hydraulic flushing device is good and the flushing efficiency is high, the effective flushing length of a single flush door can exceed 100m.

　　■ Automatic control of hydraulic flushing device without manual operation.

　　■ the bottom water inlet of hydraulic flushing device, even if the storage tank is not in full pool condition, it can ensure the automatic filling of water storage room.

　　■ Hydraulic flushing device without noise, no external power, no need for outside water, save energy, protect the environment.

　　3、 選型參數(可定制)

　　Selection parameters (customizable)